VIVAX home AJ-700, User Manual, Page: 5 / 60

AJ-700
HOW TO ASSEMBLE THE JUICER
1.
Place the Plastic Juice collector assembly
on the motor housing with the spout of right hand.
facing the direction of the Locking Handle.
Swivel until it fits into place.
2. Place the Stainless Steel sieve assembly
Firstly Ensure the white dot on blade assembly are
Correct match to the white dot on the lower coupling,
then, put down the Steel sieve into lower
coupling and assemble completely
Twist the Strainer Basket and gently push down
Until it is seated in the Juice Collector.
NOTE: The top edge of the Strainer Basket
should not be higher than the edge
of the Juice Collector when properly installed
3. Place the Pulp Chute/Juicer Cover on the
top so that the opening of the Pulp
Chute is on the side opposite the spout.
4 Lock the Pulp Chute/Juicer Cover into position
by raising the Locking Handle until it clicks into
the grooves located on both side of the Pulp
Chute /Juicer Cover.
NOTE
:
Push the Locking Handle until it is fully
Upright otherwise the Juice will not operate
.
1. Align the groove in the Food Pusher with the
small protrusion on the Inside of the Feed Tube.
2. Slide the Pulp Container into position
under the Pulp Chute.
3. If the Froth Separator is not in the Juice Jug,
Slide between the tabs inside the Juice Jug.
If you prefer to have juice with froth then the
Froth Separator is not required.
4. Place the Juice Jug or a glass under the spout.