5
4.
Preparation for work
Set the device on a hard flat surface. Adjust some table legs if necessary.
On the side of the Vivat Controller there are connectors for camera – “Camera”, power – “DC
12V”, and motor “Motor”.
Connect the power cord connector “DC 12V”, sync cable from camera to connector “Camera”
and motor cable to “Motor” connector. The connecting of the camera to Vivat Turn Table must
be performed when the power is off. The plug of the sync and motor cable should be fixed into
the housing unit.
5.
Operation of the Vivat Turn Table
5.1.
The controls
On the front panel of the Vivat Controller there are: LCD screen, control buttons and IR
remote receiver.
The LCD screen displays information about the operating mode, settings and status of the
program.
"Left" and "right" buttons are used for the menu navigation, "up" and "down" change the
settings, "center” button uses to confirm.
Pic. 1
