Vitotherm VCU1100, Instruction Manual

Page: 28 / 40

26
CO2 set | Instruction manual rev-03_May 2022
6
.
Operation
This chapter describes the main operational procedures of the CO
2
set.
6.1
.
Control panel
The CO
2
set is controlled via the control panel. This panel has a control switches and several feedback LEDs. See § 3.3
.
for an
overview of the standard components of the control panel.
6.1.1
.
Main power switch
The control panel is activated by using the main power switch on the right side of the panel.
6.1.2
.
Internal components
The control panel can be opened with a key to gain access to:
• Relays and fuses
• A power outlet and modbus connection for a service laptop
• The USB drive with the technical file of the CO
2
set
• This instruction manual
6
WARNING!
Contact with live parts can cause electric shocks, burns or even death.
f Only perform work on electrical equipment if you are an authorised electrician.
f Before you start working on electrical equipment, switch off and lock out the power supply
isolator and verify that no voltage is present.
6.2
.
Switching the CO
2
set on or off
The CO
2
set is switched on or off with the main switch. This switch has two options:
• 1 = ON
• 0 = Off.
6.3
.
Performing a system reset
A system reset must be performed after a failure in the CO
2
set has been resolved. This procedure allows the CO
2
set to be put
back into operation.
To reset the CO
2
set:
• Press the reset button on the control panel.