VITO VILALC20, Instruction Manual

Page: 22 / 36

1. To turn the laser on, slide the "ON/OFF" switch (2) to the
"ON" position;
2. To switch the laser off, slide the "ON/OFF" switch (2) to
the "OFF" position.
Never leave the laser on with no one nearby. Always
switch the laser off after each use.
Self-levelling:
The self-levelling automatically compensates on uneven
surfaces of ± 4° slope.
The laser automatically adjusts the levelling whenever
vibrations or position changes have occurred during
operation. After any levelling adjustment, to avoid errors,
you must check the position of the laser beams in relation
to the reference points.
If self-levelling cannot be performed because the laser's
base has an inclination greater than 4° to the horizontal,
the self-levelling LED indicator turns red.
If self-levelling range is over ± 4°, the self-levelling function
is disabled.
1. Place the laser on a level, stable surface or fix it on a
stand;
2. Slide the "ON/ON" switch (2) to the "OFF" position;
3. Press the laser line selector button (5) according to the
desired laser beam projection mode: horizontal, vertical
or crossed;
4. Wait until the automatic self-levelling LED indicator (4)
turns green and the projected laser lines are stable. At
this point, the self-levelling cross-line laser is ready for
operation.
Without self-levelling:
When self-levelling function is deactivated, the laser lines
are locked but not calibrated and are therefore no longer
self-levelling. You can hold the laser with your hands, place
it on an inclined surface or supports.
1. Slide the "ON/OFF" switch (2) to the "OFF" position;
2. Press the laser line selector button (5) according to the
desired laser beam projection mode;
3. While using the laser without self-levelling function, the
self-levelling LED indicator (4) turns red.
The laser does not require any additional maintenance.
However, for a continuous and trouble-free operation, you
must perform regular cleaning and proper maintenance
tasks.
Before carrying out any checking, maintenance or cleaning
work, remove the batteries from the laser.
Cleaning
Clean all laser components after each use. Wipe the self-
levelling cross-line laser with a clean, damp cloth or blow
it with low pressure compressed air Careful handling
protects the product and extends its service life.
Storage
When not in use, store the laser in a dry, clean place, free
of corrosive smoke and out of children’s reach. Remove the
battery when storing the appliance.
The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools and batteries with your
household waste!
According to the European Directive 2012/19/EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
intended for this purpose.
According to the Directive 2006/66/EC, defective or used
battery packs and batteries, must be collected separately
and disposed of to designated collection points.
You can get information regarding the disposal of the
appliances and batteries through the person in charge for
recycling in your city.