24
ASSEMBLY INSTRUCTIONS
Dust collection bag assembly
1. Put the dust bag (6) into the adapter (7);
2. Fit the dust bag adapter (7) by pushing it all the way
in; The dust is extracted directly into the dust bag
through the sanding sheet and the sanding base plate
(1/2).
3. Pull the dust bag adapter to remove it once again;
For safety reasons it is essential to use the dust
collection bag or a dust extraction system.
Installing and changing the sanding base plates
▪
Snap the sanding base plate (1 / 2) onto the sander
(the base plate only fits one way);
▪
The groove in the spindle must be in line with the
sanding base plate hole;
▪
Place the washer and tighten the screw with the
supplied hex key (5);
To remove/change just follow the previous steps in
reverse.
Installing and changing the sanding sheets
Use only sanding sheets with the corresponding
dimensions and perforated holes.
▪
Place the sanding sheet on the base plate (1/2).
Check that the holes in the sanding sheet match the
base plate.
▪
To remove the sanding sheet, you only need to pull it
out.
OPERATING INSTRUCTIONS
When working with the sander multi, you should
consider some precautions and operating procedures:
▪
Hold the sander firmly. Loss of control of the sander
can cause serious injury;
▪
When working on loose or small parts, use fixing
devices to secure the parts firmly and securely;
▪
Do not apply excessive pressure to the sander against
the workpiece/object. If the speed decreases
abruptly, reduce the pressure on the sander
immediately;
▪
Never put down the sander before the base plate
(1/2) is completely stopped;
▪
Wear hearing protection when using the sander.
Noise exposure may cause hearing loss;
▪
Switch the sander multi off immediately if any of the
following problems occur:
- Leakage of lubricant through ventilation holes;
- Damage to the sander housing;
- Damage to the ON/OFF switch;
- Appearance of smoke or characteristic burning smell;
Starting and stopping the sander
1. Before plugging in the power cord (4), make sure the
ON/OFF switch (3) is turned off;
2. Hold the sander by the handle;
3. To switch on the sander, press the ON/OFF switch (1)
to position I;
4. To switch off the sander, press the ON/OFF switch, to
position 0;
Sander handling
1. Place the entire surface area of the sanding sheet on
the material;
2. Switch on the sander multi, and move it with some
pressure on the workpiece, making circular/transverse
and linear movements;
3. Use a thicker sanding sheet for greater material
removal and a thinner sanding sheet for finishing
stages. To decide on the best type of sanding sheet to
use, perform tests before use on the final product.
The dust created while the equipment is in use can
be hazardous to health:
Always wear goggles and dust mask when sanding;
All individuals working with the sander or coming into
the work area should wear a dust mask;
•
It is forbidden to eat, drink and smoke while using
the sander;
•
This sander is used for sanding wood, iron, plastic
and similar materials;
•
It is prohibited to use this sander on plaster and
surfaces that have leaded paint;
