Vitek VT-8241, Manual Instruction

Page: 6 / 36

6
ENGLISH
•
Unpack the hot air styler and remove any stickers that can
prevent unit operation.
•
Unwind the power cord completely.
•
Install one of the attachments (8, 9, 10, 11). To do this insert
the attachment into the installation place (1) and turn it
clockwise. If the attachment is set properly, you will hear
the release button (2) click.
•
Before switching the unit on, make sure that your home
mains voltage corresponds to the unit operating voltage.
•
The unit is intended for operation with AC system and
50 Hz or 60 Hz frequency, the unit does not need any
additional settings for operating with the required nomi-
nal frequency.
•
Make sure that the operation mode switch (3) is set to the
position “0”.
•
Insert the power plug into the mains socket.
•
Use the switch (3) to set the required parameters of the air
flow, the indicator (4) will be glowing during the operation:
«0» – the hot air styler is off;
«
» – «cool» air supply;
«1» – low air flow temperature;
«2» – high air flow temperature;
Note: During the first operation some foreign smell and a
small amount of smoke from the heating element are possible,
this is normal.
•
After the hot air styler operation is finished, switch it off
by setting the switch (3) to the «0» position and unplug it.
•
Wait till the hot air styler cools down.
•
To remove the attachment, press and hold the attach-
ment release button (2) and turn the attachment coun-
terclockwise.
Overheating protection
Overheating protection switches the hot air styler off if the
temperature of the outgoing air is above the limit. If the hot air
styler is switched off during operation, set
the switch (3) to the «0» position, unplug the unit and make
sure that the inlets and outlets are unblocked. Let the unit cool
down for 5-10 minutes and switch it on again. Do not block the
air inlets during the hot air styler operation and avoid getting
of hair into its air inlet.
CLEANING AND CARE
The hot air styler is intended for household use only.
IM VT-8241_70x130.indd 6 7/23/19 7:01 PM