5
5.
Operation
•
After unpacking, check if it contains all parts in accordance with the list of elements set out
above.
Ensure that all components have no visible damage. If any doubts, please contact the
manufacturer.
The mattress should be placed on the bed in such a way that the pump is located on the side
with a patient's feet.
•
Check if the switch-key is in the “0” zero position.
•
Connect the pump to electricity.
•
Connect the pipes to the pump – insert them into the air outlet located on the pump side and on
the mattress.
•
Place the pump on hard surface or hang it on hinges. The place where the pump will stand
must be clean and dry. Dust, hair or other impurity may block the filter.
•
Please, check if the pipes are not folded or pressed.
•
Switch on the pump – set switch-key in 1 position.
•
Set the pressure regulator on maximum. It will shorten the time of pumping which usually
takes 20-30 minutes.
•
After inflating the mattress, you should choose the pressure according to the doctor’s
recommendation.
•
Then place the cover included in the pockege of the antibedsore mattress using nep and velcro
(Illustration 7).
Illustration 6.
Illustration 7.
Mattress lapels
Sheet should be placed on the cover.
Now the patient can lay on the mattress. The patient should be placed always on mattress fully
inflated, otherwise the pump may fully inflate it afterwards.
In order to receive exact instructions concerning an appropriate use and optimal pressure, please,
consult your doctor. The mattress and pump create effect of “constant movement” (changing position
of body support points), provide constant muscle massage and improve blood circulation. Thus, the
mattress is an effective tool to prevent bedsores. But the position of the patient on the mattress needs
to be changed despite of using it.
•
The mattress must be on all times.
Switching off
•
Set the switch-key into the 0 position.
•
Disconnect the pipes from the air outlet in order to prevent air from escaping.
