VITAECO HotmixHOME, Instruction Manual, Page: 12 / 30

12
To insert the mixing paddle, please match the hole at the bottom of the device with the upper pin linked to
the blades, then push down till you hear a “click”.
To remove the mixing paddle, pull it upward to remove it from the blades’ pin.
The time of usage of the mixing paddle is linked to the duration of the food preparation.
WARNING: DO NOT use the mixing paddle at speeds higher than 4 or at speed TURBO.
WARNING: DO NOT remove the mixing paddle when the glass is still hot. Wait till the mixing
paddle cools down before removing it from the bowl .
CLEANING
Clean the appliance with a damp cloth and neutral detergent, avoid cleaners that result in being too
aggressive or that make too much foam.
WARNING: Disconnect the plug from the outlet before starting the cleaning operations.
WARNING: Do not completely submerge the unit in water for cleaning.
WARNING: Do not clean the appliance with a jet of water.
WARNING: Periodically disassemble the lid’s gasket and remove the dirt that there might be between
it and the lid.
WARNING: Take care to correctly reassemble the gasket at its head, so that the lid closes correctly.
Clean the inside of the bowl with a slightly dampened, non-abrasive sponge. Do this only and
exclusively when the machine is off and cold. Before cleaning the bowl, always make sure that the blades
are dismantled, in order not to run the risk of cutting.
HOW TO OPERATE
• Place the appliance on a flat surface, so that it will be in a stable position.
• Connect the equipment to the mains voltage.
• Switch on the appliance by keeping the main switch pressed, the display will then switch on automatically
and showing the Hm HOME logo.
To ensure safety and respect of energy saving, if you do not set any parameters, after about 5 minutes the
unit will shut down, setting in “standby” position and displaying the Hm HOME logo. Just press any key to
put the device back into operation.
SETTING THE FUNCTIONS
• Select the icon of the function.
• Use the “+” and “-” buttons to set the digits.
• Set the functions necessary to make food preparations, always use this recommended sequence:
1. Temperature