VISUAL PLUS xpr BIOC-SW, User Manual, Page: 9 / 30

Biometric Readers with swipe capacitive sensor v2.0
9
a
Company
Visual Corporation Plus
3 Enrollment
4 Authentication
There are 5 user authentication modes that can be assigned by the software: Only “Finger” (BIOXR-SW, BIOC-SW),
“Finger OR Code”, “Finger AND Code” (BIOXR-SW), “Finger AND Card”, “Finger OR Card” (BIOIN PROX-SW)
The tricolour LED has three colour statuses; Orange, Green & Red. It operates only on fingerprint enrollment and stays in
an orange state before authentication.
Important Note: During user authentication the finger must be swiped in the same way as it was during the enrollment
process. This increases the chance of a successful authentication.
4.1 Authentication of a user by a fingerprint
When swiping a finger, the tricolour LED turns green for one second and beeps twice if the user is valid. For an invalid
user or a misread authentication for a valid user, the tricolour LED turns red for three seconds together with multiple
beeps.
4.2 Authentication of a user by PIN code (only BIOXR-SW)
Enter the user's PIN code (1 to 8 digits). If the PIN code entered is valid, the orange LED is lit, together with 2 audio beeps
and access is granted. If the PIN code is invalid, the red LED blinks for 3 seconds together with multiple beeps.
After 15 successive invalid PIN codes, or 15 successive invalid fingers, the system blocks for 30 seconds and the orange
LED blinks with continuous audible beeps.
The orange LED will stop blinking with the first accepted finger or PIN Code.
4.3 Authentication of a user by Fingerprint AND PIN code (only BIOXR-SW)
Enter the user's PIN code wait for 2 beeps, the tricolour LED will blink in orange and then swipe the finger within 8
seconds.
Note: For using this authentication, go to Readers/Properties and select Finger and Keycode entry mode.
4.4 Authentication of a user by Fingerprint AND Card (only BIOIN PROX)
Present the card and wait for 2 beeps, the tricolour LED will blink in orange and then present the finger within 8 seconds.
Note: For using this authentication go to Readers/Properties and select Card AND Finger entry mode.