Biometric Readers with swipe capacitive sensor v2.0
14
a
Company
Visual
Corporation
Plus
7.3
Firmware Update
Right-click on the reader and select Firmware update menu
On the Firmware update window, click on the Browse button. The default location of the firmware files installed with
PROS is in the PROS folder under "Firmware" folder. If you have a newer version, use browse to locate it.
Select the firmware file with a "xhc" extension
Check the firmware version. If the version is not greater than the existing version of the reader then do not upgrade
with this file unless specified by the Installer or manufacturer of the device.
Click on the Upload button
Wait for the update end message
Close the Firmware update window
7.4
Read reader settings
Right-click on the reader and select the Get settings menu
7.5
Upload configuration to a reader
Right-click on the reader and select the Send configuration menu
See the events panel to check the configuration flow
7.6
Sensor calibration
Right-click on the reader and select the Calibrate menu
See the events panel to check the Calibration flow
It is recommended to perform a sensor calibration once the reader has been mounted. Clean the fingerprint sensor
before calibration.
7.7
Selecting a finger for fingerprint enrollment
At least two fingerprints should be enrolled for each user in case of any abnormal situation like having an injured finger
or carrying an object by hand.
In case of low recognition, the user can register the same fingerprint twice to increase the recognition rate.