Air Handler
4
This product is designed and manufactured to comply with national codes. It is installer’s
responsibilities to install the product in accordance with such codes and/or any prevailing local
codes/regulations. The manufacturer assumes no responsibilities for equipment installed in violation
of any codes or regulations.
2.4 Replacement Parts
When reporting shortages or damages, or ordering repair parts, give the complete product
model and serial numbers as stamped on the product. Replacement parts for this product are
available through your contractor or local distributor.
3. Important Safety Instructions
3.1 Recognize Safety Symbols, Words, and Labels
The following symbols and labels are used throughout this manual to indicate immediate or
potential hazards. It is the owner’s responsibility to read and comply with all safety information and
instructions accompanying these symbols. Failure to heed safety information increases the risk of
serious personal injury or death, property damage and/or product damage.
WARNING
THIS PRODUCT IS FACTORY SHIPPED FOR USE WITH A 208-230/1/60 ELECTRICAL
POWER SUPPLY. THIS AIR HANDLER
MUST NOT
BE RECONFIGURED TO OPERATE WITH
ANY OTHER POWER SUPPLY.
WARNING
DUE TO HIGH SYSTEM PRESSURE AND ELECTRICAL SHOCK IN POTENTIAL,
INSTALLATION AND SERVICE WORK CAN BE DANGEROUS.
ONLY TRAINED AND QUALIFIED
PERSONNELS ARE PERMITTED TO INSTALL OR SERVICE THIS EQUIPMENT. OBSERVE
ALL WARNINGS CONTAINED IN THIS MANUAL AND LABELS/TAGS ATTACHED TO THE
EQUIPMENT.
WARNING
THE UNIT
MUST
HAVE AN UNINTERRUPTED, UNBROKEN ELECTRIC GROUNDING TO
MINIMIZE THE POSSIBILITY OF PERSONAL INJURY IF AN ELECTRIC FAULT OCCURS. THE
ELECTRIC GROUNDING CIRCUIT MAY CONSIST OF AN APPROPRIATE SIZED POWER CORD
WHICH CONNECTED WITH THE GROUNDING PIECE LOCATED IN THE UNIT CONTROL BOX
AND ALSO CONNECTING TO THE BUILDING ELECTRIC SERVICE PANEL. OTHER METHODS
OF GROUNDING ARE PERMITTED IF PERFORMED IN ACCORDANCE WITH THE “NATIONAL
ELECTRIC CODE” (NEC)/ “AMERICAN NATIONAL STANDARDS INSTITUTE” (ANSI)/ “NATIONAL
FIRE PROTECTION ASSOCIATION” (NFPA) 70 AND LOCAL/STATE CODES. IN CANADA,
ELECTRIC GROUDING CONFORMS TO THE CANADIAN ELECTRIC CODE CSA C22.1.
FAILURE TO OBSERVE THIS WARNING CAN RESULT IN ELECTRICAL SHOCK THAT CAN
CAUSE PERSONAL INJURY.
