VISSONIC Electronics Limited
Page 27
6. Debugging
Generally, you do not need to set the host and unit. After the system is connected, the conference system is
ready to use. The unit can display the current time. After the host is connected to the audio system, there is
sound output.
1. Adjust the main volume knob on the front panel of the conference host, and control the output gain.
Taking account of the peripheral equipment, achieve the sound pickup distance required by the project
on the premise of preventing howling.
2. Engineers can set the conference mode of the host and the maximum number of enabled microphones
according to the needs of the venue. For other settings, refer to the user manual.
When you turn on the conference processor, the initialization message of "Initializing..." will be
displayed on the screen. After 3 seconds, the home screen menu will be displayed.
Home screen
U n i t : 0 0 0 1
M I C : O v e r r i d e / 1
The information displayed on the home screen is shown in the figure above, including the number of
conference microphones connected to the system ("0001" to "4000"), conference discussion mode (Override,
Voice, Open, or Apply), and the maximum number of speeches for delegate units (1, 2, 4, or 6).
One chairperson unit can be turned on when the number is 1 or 2, and two chairperson units can be turned on
when the number is 4 or 6.
Take setting the maximum number of enabled microphones as an example. The conference mode setting
process is the same.
1. Press "Enter" on the home screen to get the following menu.
M e n u
M I C M o d e
- >
2. Press the "
▽
" button to select the Active MIC menu, which indicates the maximum number of enabled
microphones.
M e n u
A c t i v e M I C
- >
3. Press "ENTER" to enter the menu.
A c t i v e M I C : 1
- > 1 2 4 6
4. Press the "
▽
" button to select the parameter "6".
