A
DXL5000 Specifications A-1
DXL5000 User and Technical Manual
DXL5000 Specifications
This appendix contains specifications for your DXL5000
Digital Microwave System
(DXL5000).
A.1 DXL5000 Connectors
The following figure shows the connectors on the DXL5000 TX (top) and RX (bottom). The
enlarged picture shows how to connect the units together and to the network. See
on page A-2 for more information.
A.1.1
AC Power Connection
The unit has a standard IEC connector. The AC receptacle is protected by a pair
of 3-amp fuses. The power supply accepts a range of AC input voltages from
120—240 VAC at 50—60 Hz.
The following table shows the rear panel
MGMT
RJ-45 connector, which provides 10 Base T
Ethernet connection via your web browser to a PC at a local or remote location for control of the
unit.
IF IN, IF MON, ASI/DS3/E3, ASI3/SMPTE310 BNC Connectors
The following table shows a BNC connector. The signal carries on the center contact, and
voltage to the BNC carries on the outer ring.
Connector
Pin
Signal
Pin
Signal
1
TX + (out)
5
N/C
2
TX – (out)
6
RX – (in)
3
RX + (in)
7
N/C
4
N/C
8
N/C
Connector
Pin
Description
Pin
Signal
Ring
Ground
1 2 3 4 5 6 7 8
Signal
Ground
