2
Installing the DXL5000 2-1
DXL5000 User and Technical Manual
Installing the DXL5000
This chapter describes how to install
DXL5000 Digital Microwave System
(DXL5000).
CAUTION
If you modify the product without authorization from Vislink, you will void
the warranty.
2.1 Unpacking the DXL5000
Carefully unpack your new equipment to avoid damage.
Note
DO NOT discard the container or packing material until you have inspected the
equipment and are sure there is no shipping damage. The container and
packing must be available in case you need to file a damage claim with the
shipping carrier.
•
Inspect the equipment for damage and that it is clean and dry.
•
Inspect the cables, connectors, switches, and displays to ensure that they are not
broken, damaged, or loose.
If you discover damage after unpacking the system, report the damage as follows:
•
Immediately file a claim with the shipping carrier.
•
Forward a copy of the damage report to Vislink Customer Service.
•
Contact Vislink Customer Service to determine the disposition of the equipment. See
Getting Support for Your DXL5000
2.2 Preparing to Install the DXL5000
The following sections describe the things you should consider before installing the DXL5000.
2.2.1
Operating in Safety
CAUTION
Ensure that the power being supplied matches the power required by
the equipment. You can find power ratings for equipment on a rating
plate, usually on the rear panel. Ensure that the electrical supply is
protected by over
-
current protection devices as required by the
applicable electrical codes. If necessary, consult a licensed electrician.
