w w w . c l a s s i c
e x h i b i t s . c o m
Step 1
Page 1 of X
866.652.2100
© 2015
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #XXXXX -
Steps:
1) Connect verticals [2] & [3] together.
See
Q125 Connector
detail.
2) Attach base plate [1] to assembly [2/3].
3) Connect curved base plates [1A] to verticals [4].
4) Attach assemblies [1A/4] to the bottom side of counter top.
See
Counter Support Leg Attachment
detail.
5) Secure counter top to vertical [3].
See
Counter Attachment
detail.
6) Connect Monitor Mount to vertical [3].
See
Monitor Mount Attachment
detail.
7) Install Graphic Wings to A10 clips on vertical extrusions.
See
A10 Clamp
detail
Item
1
1A
2
3
4
Description
Oval Base Plate
Curved Base Plates
41”h Square Vertical Extrusion
41”h Square Vertical Extrusion
38” Round Vertical Extrusion
Qty.
1
2
1
1
2
1
2
3
Canopy
1A
1A
4
4
Counter Top
When assembled
*
*
Counter Attachment
Washer
Thumbscrew
Use thumbscrew & washer
to attach to vertical extrusion.
*
*
*
*
*
*
Counter Support
Leg Attachment
Insert screws located
on underside of counter
into holes on flange plate
and secure with wing nuts.
Wing Nut
*
Monitor Mount Attachment
Attach monitor mount to vertical
extrusions after assembly.
Slide Mount
into Groove of
Vertical Extrusion.
Tighten
Setscrew
Attach top
Plate and
tighten screws
Knob to attach graphics
Setscrew
1) Slide Connector of A10
into extrusion groove.
2) Tighten setscrew when
A10 is in desired location.
3) Insert Infill into Clamp
4) Tighten knob on A10 to
secure wing in place.
A10 Clamp Detail
Screws
Connector
Q914
Connector
Silde extrusion
over connector;
secure with screws.
**To prevent product loss,
Keep all screws attached
to connector piece after
disassembling
MOD-1524 - General Layout
