VISEZM1601-5
Z-Wave Security Siren
Firmware Version : 15.5
Quick Start
The siren can be included into any Z-Wave network by setting the controller into the inclusion mode. Once your controller is ready open the
bracket and press the program switch on the back of the siren for at least one second and release it. If the inclusion was successful the
LED Setting light will go off. If not, please try again.
Please refer to the chapters below for detailed information about all aspects of the products usage.
What is Z-Wave?
This device is equipped with wireless communication complying to the Z-Wave standard. Z-Wave is the
international standard for
wireless communication
in smart homes and buildings. It is using the
frequency of 868.42 MHz
to realize a very stable and secure
communication. Each message is reconfirmed (
two-way communication
) and every mains powered node can act as a repeater for other
nodes (
meshed network
) in case the receiver is not in direct wireless range of the transmitter.
Z-Wave differentiates between Controllers and Slaves. Slaves are either sensors
(S)
transmitting metered or measured data or
actuators
(A)
capable to execute an action. Controllers are either static mains powered controllers
(C)
also referred to as gateways or
mobile battery operated remote controls
(R)
. This results in a number of possible communication patterns within a Z-Wave network that are
partly or completely supported by a specific device.
