VISION X XMITTER
TIP:
Vision X recommends the use of liquid thread-locker, or Locktite, to
ensure that every bolt and nut are safely secured.
WARNING: Bolts, Nuts, and Washers are Stainless Steel. DO NOT USE
Pneumatic or Electric Tools to Tighten and Loosen. The Hardware Will
Permanently Lock Together.
LIGHT ANGLE ADJUSTMENT
1. For the Wing Mount option, simply loosen the bottom wing nut (Fig. 4) on
each end and rotate light bar to desired angle. Fasten when completed.
2. For the Feet Mount option, use the provided allen wrench to loosen both
the Allen bolts on each side the light bar. Once desired angle is achieved,
tighten the bolts.
3. A good reference point is at 20 ft; the top of the beam should be 3” down
from center of light (with the light bar at dead center). Tighten light and
enjoy.
MOUNTING INSTALLATION FOR WINGS
INSTALLATION IMAGES
(M1)
(M2)
(M3)
Mounting Wing
(W1)
Fig. 1
Fig. 3
Fig. 3
MOUNTING INSTALLATION FOR FEET
1. Start by setting the light bar in the location that you plan to mount it in.
Mark each end of the light bar and measure the length.
2. Depending on the length of your light bar, you will have a certain number
of mounting feet [F1] included in the packaging. These feet fit into grooves
on the back of the light bar. (See Figure 1)
3. Place each mounting feet [F1] (with bolt head pointing into light bar) into
the feet grooves on the back of the light bar. (See Figure 2)
4. Mark the location of each mounting feet on your vehicle. Drill holes for
each. The feet can slide inside the grooves, letting you fine tune the
location.
5. Remove the nut from the feet bolt, and place the light bar onto your
vehicle, line up the bolts with the previously drilled holes. (See Figure 2)
6. Securely tighten the nut to the mounting feet bolt.
Disassembled Foot Mount, included with every Vision
X LED Light Bar. Comes assembled.
