Commissioning
Technical Manual
Version 1.5
9
5.3
Assembly
On the back of the MDL, either a flange clamping piece (for mounting to round tubes
18x1.5mm) or an aluminium joint (for mounting on item profiles) can be mounted with the
help of slot nuts. In order to rotate an MDL with a flange clamping piece by 90°, it is advisable
to install a dedicated adapter plate between the MDL and the flange clamping piece.
Fig.:1 Flange clamping piece FK18
Fig.:2 Aluminium joint 8 40x40
Fig.:3 Adapter plate 90° for FK18
NOTE!
It is recommended that for MDLs with sizes larger than 300mm, either
two
flange
clamping pieces or
two
aluminium joints should be installed!
