VisioBraille Visio 500, User Manual, Page: 12 / 52

First Steps 12
How to position Visio 500 on your desk
Until now Visio 500 was just positioned coarsely. Visio 500 should be
positioned that the reading table pulled out fully should flush with the
front rim of the table.
We deliver Visio 500 with a locked reading table. To open it, pull the front
lever of the reading table to the left. The reading table should now move
freely in all directions. Now test if the Visio 500 is positioned correctly.
Pull out the reading table to the stop. It must not protrude your desk.
Otherwise you have to adjust the position of Visio 500.
Attention:
Never move or lift Visio 500 while holding on the reading table. Always
move it while lifting on the locked monitor arms. If Visio 500 is lifted on
the reading table it can be damaged. See images at page 8.
If you have to adjust Visio 500 push the reading table back and the front
lever to the right to lock the reading table.
Now push the monitor arms slightly below the horizontal position and
lock the monitor arms with the button on the left back of the device
pushed towards the outside (right if viewed from rear). If you lift Visio 500
now the arms should be locked in horizontal position and you can lift and
move the device.
After that, open the lock of the monitor arms. This will only work if the
monitor arms a slightly pushed below the horizontal position. After that
release the reading table break by pushing the front lever of the reading
table to the left.
Visio 500 is now ready to be used
If you want to bring Visio 500 back in transport position, read chapter
“Transporting Visio 500”