VSP 516 Quick Start
Rev 1.0
Page 1 of 3
–
Installation and cabling features
Connections
Step 1-Mounting
Turn off or disconnect all equipment power sources.
Step 4- Composite Input
Used to input composite signal
(PAL, NTSC, SECAM compatible).
Step 3-SDI Input
Used to connect the SDI source such as digital
camera, broadcasting device. SDI input is an
optional module of VSP 516S, based on the
standard VSP 516.
Note
Step 6-DVI input
Input the signal from computer,
DVI signal generator and so on.
Step 7-Component input
Used to input signal from DVD
Or media player; Input signal are R/Pr G/Y B/Pb
from left side if check from back panel.
Step 5-S-Video input
Used to input S-Video signal
(PAL, NTSC, SECAM compatible).
Step 8-VGA input
Input from computer or VGA
source, such as PC or laptop.
Connect to the monitor or LED control
system which has DVI interface.
Step 10-DVI output
Step 11-VGA output
Connect to the monitor, projector and
so on.
2
3
4
5
19
1
23
~
24
25
26
29
30
31
21
SDI input BNC connector
15 16
18
17
28
~
~
14
20
Mini Switches
LAN RJ-45 port
USB control port
RS232 control port
Audio input
connector
TX Card Power Connector
TX Card DVI Input Connector
Composite input BNC connector
S-Video (DIN 4) Input connector
DVI (DVI-I) Input Connector
Component Female BNC Connector
DSUB 15-pin VGA Output Connector
Audio output
connector
DVI Output Connector
33
34
32
DSUB 15-pin VGA Output Connector
Power Switch Button
Power Cord Connector IEC-3
Step 2-Audio Input
Used to input audio signal from Players
with audio output, such as DVD.
Step 9-Audio output
Connect to the audio Amplifier or audio
player.
Step 12-USB connector
Connect VSP516 with PC by USB cable
for control.
This guide provides quick start instructions for an experienced
installer to set up and operate the VSP 516.
