Switching on for the very first time after assembly
8
5
Switching on for the very first time after
assembly
You can skip this chapter, as the following steps were usually carried out when
the device was delivered and are only mentioned here for the sake of complete-
ness.
Connect the power pack of your VISIO 24 to a live power socket and the plug on
the other side of the power pack into the camera unit. The power supply input
(see Figure 2) is on the right-hand side of the camera unit. The ready LED lights
up immediately after plugging in and lights up continuously.
Picture 2
Power IN
HDMI© output
Readiness LED
Power-OUT to display
Control-panel connector
