PART A: Basic machine
Shredder
L 60; L60+
©
VIRTUS EQUIPMENT 2018 All rights reserved
Page 37
6.5
Machine check prior to initial start-up
Check
See chapter
1.
When housing flap is opened, check the
knife mounting screws using a torque
wrench.
Replacing and checking the cutting knife
mountings.
2.
Search the grinding chamber for foreign
matter.
Cleaning the machine
3.
Check oil level of the gear box motor
motor Maintenance
4.
Examine in feed device (accessories) for
foreign matter.
Part B: Accessories.
5.
Check that the
Emergency Stop buttons
are unlocked.
6.
Check all safety devices for proper
functioning.
Checking the protective devices.
7.
Switch on machine for a short time and
check rotational direction. The rotational
direction can be seen at the discharge air
fan of the drive motor (observe running
direction arrow).
Electrical connection.
8.
Allow machine to run for approx. 10
minutes without grinding material.
Switch on machine.
9.
Connect material discharge device
(accessories) and in feed device
(accessories), check rotational direction
drives.
Part B: Accessories.
10. Feed grinding material uniformly. Too
much grinding material can lead to
overload of the machine.
Manual in feed of grinding material.
11. If necessary, check the temperature of the
ground material.
12. Monitor the ammeter. This displays the
present current consumption and in this
way gives information on the load of the
machine.
