Chapter 8 System Configurations 24
A special Intergraph driver is required to configure the GLZ boards to provide
180Hz RS170 video output. As of this writing, that driver has not been for-
mally released. We are using a test version of the driver on our system.
It is not necessary to use two GLZ board in the system shown above. If you
use one GLZ board, plug the GLZ output into the LEFT/MONO input of the
FS5 and move the MONO/STEREO switch to MONO.
Division Provision1 0 System Configuration
In preliminary tests with Division, we had no problem running the FS5 directly
from the PVlO in mono and stereo modes.
As of this writing, Division is awaiting delivery of an FS5 for verification test-
ing with the FS5 prior to a formal release of the software driver.
Contact Division directly for further details of system configuration.
SGI Reality Engine System Configuration
We have tested the following system configuration to some extent:
electromagnetic transmitter
to @NC
Hitachi
Pm
21”
To deliver the correct video format to FS5, a new video output format (VOF) is
required. A tape with the VOF will be shipped with your FS5 if you are using
an Onyx. The format is titled 64Ox480_18Oiq.u.
