USER MANUAL
1
ENGLISH
INTRODUCTION
This manual will help you get the most from your floor machine. Read it thoroughly before operating the
machine.
This machine is intended for Commercial use. It is constructed for use in an indoor environment and is not
intended for any other use. Use only recommended accessories
.
(A)KNOW YOUR MACHINE
1. Switch Lever Safety Lock Button
2. Operator Handle Grips
3. Accessory Lever
4. Solution Tank (Only for DS350)
5. Accessory Power Plug
6. Handle Release Compression Lever
7. Switch Levers- Squeeze-ON / Release-OFF
8.Operator Handle
9. Solution Fitting (Only for DS350)
WARNING!
This machine contains moving parts. To reduce the risk of injury, always unplug the power cord before
serving.
(B)INSTALLING THE BRUSH OR PAD HOLDER
Align the lugs(A) with the corresponding Slots(B) in the brush or pad holder and turn the brush or pad holder
counter clock wise to lock it in place. To remove brush/pad holder, give it a quick, hard turn clockwise.
CAUTION!
Using the wrong brush or pad on this machine can damage the floor or overload the motor.
OPERATION
1. Pull out and turn the Cord Hook to release the Power Cord. Unwrap the Power Cord
and plug it into a
properly grounded outlet;
2. Pull up on the Handle Release Compression Lever
(6)
. Move the Operator Handle
(8)
downward until
your arms are almost straight. Release the Handle Release Compression Lever
(6)
to lock the Operator
Handle
(8)
in place;
3. Lift up on the Operator Handle
(8)
until the brush (or pad) is flat against the floor.
WARNING!
Be prepared to control the machine as soon as the motor starts. Just a slight up or down movement of the
Handle will make the machine move from side to side. Raise the Handle to go right. Lower the Handle to go
left.
CAUTION!
Immediately start moving the machine back and forth. Keep the machine moving while the motor is running to
avoid damage to the floor.
4. Hold the Operator Hand Grips
(2)
firmly, push the Safety Lock Button
(1)
and then compress the Switch
