Manual VIPA TM-E
Chapter 4
Deployment TM-E
HB39E - TME - RE_900-1E650 - Rev. 09/11
3-5
Assembly
The modules are installed on a profile rail. You may use the following
standard 35mm profile rail:
35 mm
27 mm
15
m
m
1,
5 m
m
35 mm
27 mm
7,
5 m
m
1 m
m
The following sequence represents the assembly procedure as viewed
from the side.
•
Install the profile rail. Make sure that a clearance of at least 100mm
exists above and 70mm below the middle of the profile rail.
100 mm
70 mm
Clack
•
Insert the module that you are installing into the profile rail at an angle
of about 45 degrees from the top and rotate the module into place until
it clicks into the profile rail with an audible click.
General
Assembly
procedure
