VIPA System 200V IM Series, Manual

Page: 63 / 348

Manual VIPA System 200V
Chapter 3 Profibus DP
HB97E - IM - Rev. 06/29 3-31
IM 208DP - Master - Overall reset
Starting with the firmware version V3.0.6 of the DP masters, you have the
possibility to request an overall reset at the DP master.
An overall reset clears all data in the Flash-ROM.
1. Turn on the power supply of the System 200V.
2. Push the operating mode lever of the master module in position
MR. Hold it for app. 9s.
→
first, the MC-LED blinks 3 times. For 3s the blinking switches
into permanent on. Then, the IF-LED blinks 3 times and
switches to permanent on.
3. Release the lever and tip it within 3s once more in pos. MR.
→
The content of the Flash-ROM is deleted. The operation has
been executed properly when the green R-LED blinks 3 times
and the IF-LED is permanent on.
Clear
R
E
IF
DE
MC
R
E
IF
DE
MC
R
E
IF
DE
MC
R
E
IF
DE
MC
R
E
IF
DE
MC
R
E
IF
DE
MC
RN
ST
MR
OK
3x
RN
ST
MR
3s
3x
RN
ST
MR
Tip
R
E
IF
DE
MC
R
E
IF
DE
MC
3x
RN
ST
MR
9s
max. 3s
As soon as you switch the master to RUN, this boots and starts with
its default parameters at the bus.
Default parameter: Address: 2, Transfer rate: 1.5MBaud
If there is a valid profibus project in the CPU, this is automatically
transfered via backplane bus into the RAM of the 1
st
master after Power
ON - independet from position of operating mode lever.
General
Execute an overall
reset
Project
engineering via
CPU after power-
on to first master