VIPA System 200V IM Series, Manual

Page: 59 / 348

Manual VIPA System 200V
Chapter 3 Profibus DP
HB97E - IM - Rev. 06/29 3-27
IM 208DP - Master - Slave operating mode
Starting with CPU firmware 3.72 there is the possibility to use the IM
208DP as DP slave. The VIPA04D5.GSD is needed for connection to a DP
master system.
For hardware technical reasons this functionality is not available for the IM
208DPO master with FO.
For deployment of the IM 208DP as DP slave 3 hardware configurations
are needed, which were described in the following:
CPU IM208DP
Slave system
1 2
Master system
3
➀
Hardware configuration System 200V
Project engineering Siemens CPU 315-2DP with virtual Profibus slave
(address 1) for System 200V. The DP slave contains CPU 21x, I/O
periphery and IM 208DP (set parameter
Transfer project to IM 208
to
"No"). Project is to be transferred to the CPU 21x.
➁
Hardware configuration IM 208DP
Project engineering IM 208DP as Siemens CPU 315-2DP with Slave-
Operation of the DP part. Use
Properties
to set Profibus address and
I/O area and transfer the project to IM 208DP.
➂
Hardware configuration superordinate master system
Project engineering of the superordinate master system. Connection of
the IM 208DP (slave) as CPU2xxDP. Here the VIPA04D5.GSD is
needed. Use
Properties
to set Profibus address (identical to hardware
configuration IM 208DP) and I/O areas as "modules". The project is to
be transferred to the CPU of the master system.
Overview