VIPA System 200V IM Series, Manual

Page: 277 / 348

Manual VIPA System 200V
Chapter 6 DeviceNet
HB97E - IM - Rev. 06/29 6-17
Diagnostics
The LEDs installed to display the status allow extensive diagnostics during
the POWER ON - procedure as well as during operation. The result of the
diagnosis is determined by the combination of the different LEDs and the
current operating mode.
Explanation:
LED Description
off LED turned off
on LED is permanently on
blinks LED blinks
The following operating modes are available depending on the position of
the address selector:
•
DeviceNet mode (address selector in position 0...63)
•
Configuration mode (address selector in position 90...92)
LED
Description
PW on After POWER ON the PW-LED is turned on and
ER off indicates a properly operating power supply. The RD-
RD blinks LED blinks since the configuration data, stored in the
BA off EEPROM, was transferred successfully into the
peripheral modules
PW on After POWER ON the PW-LED is turned on. The ER-
ER on LED is on due to errors on the backplane bus or when
RD off the configuration data could not be transferred into the
BA off peripheral modules.
Overview
DeviceNet mode
POWER ON
without DeviceNet