VIPA System 200V CM, Manual

Page: 37 / 48

Manual VIPA System 200V Chapter 3 Power supplies - PS
HB97E - PS-CM - Rev. 06/29 3-9
Wiring
The connections to the power supply are provided by spring-clip terminals.
The terminals are able to accommodate wires of a diameter from 0.08mm
2
to 2.5mm
2
. You may use flexible multi-strand wires as well as solid
conductors.
Connect cables to the spring-clip contacts as follows:
The sequence shown on the left explains the steps that you have to follow
to wire the power supply.
•
Insert a suitable screwdriver at a slight angle into the square hole as
shown.
•
Push and hold the screwdriver in the opposite direction to open the
spring contact.
•
Insert the stripped end of the interconnecting wire into the round hole.
You may use wires of a diameter of 0.08mm
2
to 2.5mm
2
.
•
When you remove the screwdriver the inserted wire is clamped and
connected securely by the spring-clip contact.
Danger!
•
You have to disconnect the power supply from the main power source
before commencing installation or maintenance work, i.e. before you
start to work on a power supply or the supply cable, the main supply line
has to be disconnected (disconnect plugs, on permanent installations,
the respective fuse must be turned off)!
•
Only properly qualified electrical staff is allowed to install, connect
and/or modify electrical equipment!
Wiring
Wiring by means
of spring-clip
terminals
Round opening for wires
Square opening for screwdriver