VIPA SLIO System FM 050-1BA10, Manual

Page: 39 / 56

Manual VIPA System SLIO
Chapter 3 Deployment
HB300E - FM - RE_050-1BA10 - Rev. 10/30 3-7
Parameter data
Via parameterization you may define among others:
•
Interrupt behavior
•
Input filter
•
Counter operating mode res. behavior
•
Load value
and
end value
DS = Data set for access via CPU, Profibus and ProfiNET
IX = Index for access via CANopen
SX = Subindex for access via EtherCAT
Name Bytes Function Default DS IX SX
DIAG_EN 1 Diagnostic interrupt* 00h 00h 3100h 01h
CH0A 1 Input frequency track A 02h 01h 3101h 02h
CH1B 1 Input frequency track B 02h 01h 3102h 03h
CH2R 1 Input frequency Reset 02h 01h 3103h 04h
CH3 1 reserved 00h 01h 3104h 05h
INT_I 1 Interrupt behavior* 00h 80h 3105h 06h
FCT_I 1 Counter function* 00h 80h 3106h 07h
MODE2_I 1 Counter mode 2* 00h 80h 3107h 08h
MODE3_I 1 Counter mode 3* 00h 80h 3108h 09h
END_I 4 End value 00h 81h 3109h...310Ch 0Ah
LOAD_I 4 Load value 00h 81h 310Dh...3110h 0Bh
HYST_I 1 Hysteresis 00h 81h 3111h 0Ch
CRES 1 reserved 00h 81h 3112h 0Dh
* This parameter may only be transferred at STOP state.
Byte Bit 7 ... 0
0 Diagnostic interrupt
00h = disable
40h = enable
•
Here you activate res. de-activate the diagnostic function.
Byte Function Possible values
0 Input frequency track A
1 Input frequency track B
2 Input frequency Reset
3 reserved
00h: 500kHz 06h: 10kHz
01h: 300kHz 07h: 5kHz
02h: 100kHz 08h: 2kHz
03h: 60kHz 09h: 1kHz
04h: 30kHz
Other values are not permissible!
•
Input frequency
allows you to preset a filter for input track A, track B and
reset. With the help of filters you may e.g. filter signal peaks at a blurred
input signal.
Overview
DIAG_EN
Diagnostic
interrupt
CHxx
Input frequency