VIPA SLIO FM 050-1BB00, Manual, Page: 37 / 56

Manual VIPA System SLIO
Chapter 3 Deployment
HB300E - FM - RE_050-1BB00 - Rev. 10/30 3-5
In-/Output area
The following areas of the in-/output area are used by the 050-1BB00:
At CPU, Profibus and ProfiNET the input respectively output area is
embedded to the corresponding address area.
IX = Index for access via CANopen with s = subindex, depends on number
and type of counter
SX = Subindex for access via EtherCAT
Addr. Name Bytes Function IX SX
+0 CV_I 4 Counter 0: Counter value 5400h/s 01h
+4 CV_II 4 Counter 1: Counter value 5401h/s+1 02h
+8 CSTS_I 2 Counter 0: Counter status 5402h/s 03h
+10 CSTS_II 2 Counter 1: Counter status 5403h/s+1 04h
The
counter value
always contains the current value of the corresponding
counter.
Bit Name Function
0 - reserved
1 STS_CTRL_COMP is set when
comparison bit
is enabled
2 STS_SW-GATE Status software gate
(set when
SW gate
is active)
3 ... 4 - reserved
5 STS_GATE Status internal gate
(set when internal gate is active)
6 STS_COMP Status
comparison bit
7 STS_C_DN Status set at counter direction backward
8 STS_C_UP Status set at counter direction forward
9 STS_CMP* Status comparison is set when the comparison
condition is met. If comparison is
parameterized
never
, the bit is never set.
10 STS_END* Status is set when
end value
was reached
11 STS_OFLW* Status is set at overflow
12 STS_UFLW* Status is set at underflow
13 STS_ZP* Status is set at zero run
14 ... 15 - reserved
*
The bits remain set until reset with RES_SET (bit 6
control word
).
Overview
Input area
12byte
CV_I
CV_II
Counter value
CSTS_I
CSTS_II
Counter status