110
3.13 On the underside of the tripod bowl, remove and discard the screw
securing the
corresponding leg clamp
. Do not remove the washer
.
3.14 Position the bowl strap anchor
on the leg clamp, ensuring it is correctly oriented. Using Loctite
221, secure the bowl strap anchor with the 25 mm M6 screw
supplied with the strap. Tighten
screw to a torque of 4.5 Nm (40 lbf in.).
3.15 Using the karabiners
, clip the strap
to the strap anchors and adjust to length.
Installation - 100 mm EFP tripods
4
Install the carrying strap on 100 mm bowl EFP tripods as follows:
4.1
On the lower moulding of the leg with the strap, drive in the 'knock-out' using a suitable tool. If
possible, remove the blank from inside the moulding to prevent subsequent rattle.
4.2
into the hole in the lower mouldings
.
4.3
Install a washer
and screw into the captive nut
4.4
At the leg hinge, remove screw
and replace with the longer strap anchor
, using Loctite
221 on the thread and white Chesterton grease under the countersink.
4.5
Attach the split ring
4.6
Using the karabiners
, clip the strap
and split ring
and adjust
to length.
NOTE:
The shorter, M5, strap anchor should be fitted in the lower moulding and the longer, M6, at
the leg hinge.
Summary of Contents for Vision Pozi-Loc
Page 1: ...Contents Vinten Camera Control Solutions Next Page Previous View Vision Pozi Loc Tripods ...
Page 8: ...8 Contents Previous Page First Page Next Page Previous View Part 1 Illustrated Parts Lists ...
Page 85: ...85 Contents Previous Page First Page Next Page Previous View Part 2 Repairs ...