104
Replacing tripod legs (100 mm EFP tripods)
Introduction
1
The legs are secured in the bowl assembly by leg retainers. Each leg retainers is secured by two
screws.
Consumables
2
The following consumables will be required:
Loctite 221 (Vinten Part No. Z002-026)
White Chesterton grease (Vinten Part No. Z150-105)
Removal
3
Remove the tripod leg as follows:
3.1
Remove two screws
securing each leg retainer
3.2
Pull off the tripod leg
. Remove two screws
and nuts
securing leg retainers
to leg.
Installation
4
Install the tripod leg as follows:
4.1
Apply white Chesterton grease to underside of countersink on two screws
4.2
Secure two leg retainers
to leg
with screws
and nuts
using Loctite 221. Do not
tighten screws fully at this stage.
4.3
Position leg in the bowl
and secure each leg retainer with two screws
using Loctite 221. Do
not tighten screws fully at this stage.
4.4
Tighten screws
to a torque of 3.39 Nm (30 lb in.).
4.5
Ensure that the gaps between the tripod head and the top moulding
are equal. Adjust the
position of the leg retainers
Summary of Contents for Vision Pozi-Loc
Page 1: ...Contents Vinten Camera Control Solutions Next Page Previous View Vision Pozi Loc Tripods ...
Page 8: ...8 Contents Previous Page First Page Next Page Previous View Part 1 Illustrated Parts Lists ...
Page 85: ...85 Contents Previous Page First Page Next Page Previous View Part 2 Repairs ...