18
Optional equipment
Carrying strap
A carrying strap
is available as an optional accessory and is installed as follows
On the lower moulding of the leg with the strap, drive in the 'knock-out'
using a suit-
able tool. If possible, remove the blank from inside the moulding to prevent subsequent rat-
tle.
Push a blind captive nut
into the hole in the lower moulding.
Using a suitable M5 screw, fully compress the blind captive nut. Remove the M5 screw.
and screw into the captive nut
. Ensure that the hole in the strap anchor is oriented so that the karabiner
can
be attached.
On the underside of the tripod bowl
, remove and discard the screw
securing the
corresponding leg clamp
. Do not remove the washer
.
Position the bowl strap anchor
on the leg clamp, ensuring it is correctly oriented. Us-
ing Loctite 221, secure the bowl strap anchor
with the 25 mm M6 screw
sup-
plied with the strap. Tighten screw to a torque of 4.5 Nm (40 lbf in.).
Using the karabiners
to the strap anchors and adjust to length.
Dollies
The PRO-5
plus
system may be mounted on a variety of OB and studio dollies, which are listed un-
der
on page 24.
Summary of Contents for PRO-5Plus
