W Series
Installation Instructions for W Series Single (WS-LEFT & WS-RIGHT)
• 1 “Single” Rack
• 2 Screws
• 2 Toggle Bolts
• 2 Mounting Hole Caps
• Phillips head screw driver
• Level
• Pencil
• Tape Measure
• Drill
Parts List
Required Tools
Side Note:
Concrete, Brick or Stucco: 3/16” x 1 ¼” masonry screw or #8 x 1 ¼ inch screw with appropriate size
expanding concrete anchor - not included
Figure A
Figure B
1. Mark the mounting hole locations –
(See
image below) to ensure appropriate minimum clearance
around the Single and hold the rack against the wall.
Use a level to ensure the rack is horizontal and mark the
mounting hole locations on the wall.
2a. Drill anchor holes for drywall –
Drill
1/16 in pilot holes to determine if the holes are over
a stud. Drill ½ in (13.7mm) hole for the Toggle Bolts
centered on the marked hole locations.
2b. Install into wood –
use a screw to fasten
the strip into the wood/stud at mounting point.
