Island Display Rack 3 & 4
Assembly Instructions for IDR3/IDR4 wine racks
• (2) IDR3 or ID4 UPRIGHT
• (6) WS33 or WS43
• (3) IDR-CR3
• (1) IDR-PR
• (18) WS Assembly Screw
• (2) 14mm (or adjustable) wrenches
• 8mm Nut Driver (included)
• Alignment Tool (included)
• Drill with #2 Phillips Bit
Starter Kit Included Parts
Required Tools
Figure A
Figure B
1. Thread Footer Pads
Thread footer pads into the bottom of the uprights. Lay
down one upright and attach all crossrails using the
provided assembly screws in pre-drilled holes. Standing
first upright up, attach second upright to crossrails.
FIGURE A
If using optional casters, please refer to those
instructions for installation steps.
2. Build the Frame
Lay down one upright and attach all three crossrails
using the provided crossrail assembly screws in the
predrilled mounting holes. Do not fully tighten at this
point to allow for adjustments during assembly. Stand up
first upright and attach the second upright to crossrails.
3. Attach the Racks
Using two base cradling sides of the W Series wine
racks (wider bottle holding impressions), and starting on
the left side of the assembled frame, align the mounting
holes in racks with the holes on crossrails. Temporarily
place alignment tool through center hole in first rack,
• (4) Footer Pad
• (12) Crossrail Assembly Screw
• (2) IDR-PR Assembly Bolt
• (3) IDR-PR Assembly Screws
• (4) IDR-PR Assembly Washer
Note:
IDR Extension package contain only 1 IDRx-UPRIGHT and 2-footer pads
crossrail and the center hole in second rack. Attach
racks to crossrails. After securing top and bottom
of racks, remove alignment tool and replace with
assembly screw. Repeat for each rack set, alternating
between base and neck sets.
FIGURE B
4. Assemble Presentation Rack
Position presentation racks back to back as
shown. Using nut driver (included), a Phillips head
screwdriver (not included) attach presentation racks
Summary of Contents for IDR3
Page 3: ......
