Vino Pins (VP-WD & VP-X) Installation Instructions for Wood Surfaces
Wine Master Cellars, LLLP • 10645 E 47th Ave, Denver, CO 80239 • phone: 866.650.1500 • fax: 866.650.1501 • VintageView.com
Required tools:
•Level •2 X 10mm (or adjustable)wrenches •Drill •5/32 inch (4mm) drill bit
Starter Kit Included Parts
: •1 Vino Pins Neck •2 Machine/Lag Studs •1 Vino Pins Base •2 Nuts
Figure B
1.
Mark the mounting hole locations
- Reference
Figure A below to verify appropriate minimum clearances
around the Vino Pins in the desired installation area. Use
a level to ensure the printed template is horizontal along
the long edge and mark the hole locations by piercing
the template with an awl or a screw at the center of the
2 marks corresponding with the bottle direction chosen
earlier.
Note:
For Magnum bottles (1.5L) increase the horizontal
distance between the neck and base Pins by 1 inch from
7-1/2 inches to 8-1/2 inches (216mm).
4 3/8"
13"
7 1/2"
5/8"
2 3/4"
2 3/4"
Figure A
2.
Drill the pilot holes
- Drill a 5/32 inch (4mm) pilot
hole for the Machine/Lag Studs at the marked locations
(Figure C).
Figure C
Extension Kit Included Parts
: •1 Vino Pins Neck Extension •2 Studs •1 Vino Pins Base Extension
Before you begin, choose the direction the bottle necks should point
If the bottle necks are to point to the right, the base pin
must be installed to the left of the neck pin.
If the bottle necks are to point to the left, the base pin
must be installed to the right of the neck pin.
Critical Note:
These installation instructions are for attaching Vino Pins only to solid wood or plywood surfaces with a minimum thickness of 1/2 inch
(12.7mm). If your wall surface does not meet this minimum requirement, please contact your VintageView supplier to obtain appropriate mounting
hardware for your wall surface. Installing Vino Pins on wall surfaces that do not meet this minimum criteria may result in failure of the installation
and serious damage or injury.
