There are two pre-drilled mounting holes in each rack. Appropriate fasteners for your wall surface must be utilized in
both mounting holes for proper installation. Fasteners for drywall and wood surfaces are included with your rack. We
recommend the following fasteners for these surfaces:
Fasteners:
•
Attaching to drywall, use the 2 included Toggle Bolts
•
Wood wall surfaces can use 2 included Screws (#8 X 1 ¼”)
•
Concrete, Brick or Stucco: 3/16” x 1 ¼” masonry screw or #8 x 1 ¼” screw with appropriate size expanding
concrete anchor
Vino Styx Installation Instructions
Wine Master Cellars, LLLP • 10645 E 47th Ave, Denver, CO 80239 • phone: 866.650.1500 • fax: 866.650.1501 • VintageView.com
Required tools:
Phillips Head Screw Driver
Level
Pencil
Drill and 1/2 inch drill bit
Tape Measure
Included Parts
: 1 Vino Styx
2 Toggle Bolts
2 Screws
2 Mounting Hole Caps
Figure B
1.
Mark the mounting hole locations
- Reference
Figure A below to ensure appropriate minimum clearances
around the Vino Styx and hold the rack against the
wall. Use a level to ensure the rack is horizontal and
mark the mounting hole locations on the wall with a
pencil (Figure B) before setting the Vino Styx aside.
1 13/16"
1 13/16"
3 1/2"
3/8"
13"
4 7/8"
Figure A
2.
Drill the anchor holes
- Drill a 1/2 inch (13.7mm)
hole for the Toggle Bolts centered on the marked hole
locations (Figure C).
Note
: If attaching to a wood wall surface more than 1/2
inch thick or if a hole location is over a stud, do NOT drill
the hole for the Toggle Bolt. Instead, a Screw should
be used to fasten the strip into the wood/stud at that
mounting point.
Figure C