Portofino Series Thermoelectric Models – Replacing the Cooling Chip
These instructions apply to the following models only: VT-BORDEAUX1, VT-BORDEAUX2C, VT-
BORDEAUX2H, VT-RIOJA 1, VT-RIOJA 2, VT-RIOJA 4, VT-BLEEKERBAR,VT-KENDALL WB, VT-
CHELSEA WB, VT-HAMILTON 3, VT-PORTOFINO3D, VT-BLEEKER2
The electronic components that you will be receiving are simple plug in and plug out parts.
Be sure to have the unit
unplugged
while performing the installation
.
TOOLS REQUIRED: Phillips Head Screw Driver
1.
Remove the cooling system from the back of the unit by unscrewing the four outer screws as
shown above.
Summary of Contents for Portofino VT-BLEEKER2
