Page 4
shading solutions by
VIMCO
TM
FASTENING MOUNTING BRACKETS
A.
Position the indentions on each bracket (see diagram below) at the desired fabric location. These indentions
designate where the tube edges should lie once the shade roller is in place. Use a level to ensure both brackets are
at the same height and parallel to the window casing.
Note:
Fasten the top of the brackets 8 1/2 in. (220 mm) from the top of the window trim to ensure complete
window exposure when the shades are in full open position.
B.
Fasten the brackets to studs in the wall using no less than six (6) hex-head self-drilling screws.
Note:
All six (6) screws must be securely fastened to a stud or other structural member.
CAUTION!
Sivoia
®
High Torque Roller Shades can weigh up to 225 lbs. (102 kg), depending on the size and
fabric type. Make sure the mounting brackets are fastened to structural elements rated to support such loads.
Before AND after the mounting brackets have been fastened to the wall, confirm the
Tube Length
dimension (see pg. 3). Make any necessary bracket position adjustments based on this assessment.
Bracket Indentions as guides
for Tube Edges
Bracket Indentions as reference
for Tube Edges
Wall Mount
Ceiling Mount
Ceiling Mount
Wall Mount
8 1/2”
(22 cm)
Tube Length
2
