CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER(OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
ISO14001
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER(OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
ISO14001
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER(OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
ISO14001
The arrow symbol in the shape of a lightning flash inside an equilateral triangle is intended
to alert the user of the presence of uninsulated dangerous voltage inside the product's
container, that may be of sufficient intensity to pose a risk of electric shock to people.
The symbol of the triangle with an exclamation mark is intended to alert the user of the
presence of important operating and maintenance (servicing) instructions in the
documentation accompanying the device.
INFORMATION: This equipment has been tested and found to comply with the limits set for
a Class A digital devices, pursuant to Part 15 of the FCC and CE standards.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, it may cause harmful interference to
radio communications.
The use of this equipment in a residential area is likely to cause harmful interference that the
users might have to correct at their own expense.
WARNINGS: Changes or modifications not expressly approved by the manufacturer could void the user's
right to operate the equipment.
CAUTION: To avoid the risk of electric shock and fire hazards:
☞
DO NOT use power sources other than those specified.
The installation must be performed by a qualified technician and it must comply with all
local regulations.
1. Tips for Installation
• Make sure the camera is able to perceive the IR light on the same
wavelength as the illuminator.
• Choose the most appropriate illuminator, depending on the angle of
emission and on the indicated capacity.
• Test the illuminator in complete darkness, because it won't turn on if
there's enough brightness for a colour camera shoot.
• Avoid the presence of strong light sources, such as street lamps or
reflected light that would prevent activation.
• Place the illuminator about 10/13 feet above the ground, not far from the
area to be lit, otherwise the lighting effect will be mitigated.
• The light should be installed above the (or along side of) the camera.
• IT IS also possible to arrange the illuminator at another point, but not in
front of the camera.
• The lighting capability is highly variable depending on many factors,
including the refraction from the surrounding environment, the sensitivity
of the camera, and, especially, the focal length and aperture.
• PLEASE, keep in mind that the nominal lighting capacity is tested with
focused lenses, while using wide-angle lenses will reduce it drastically
2. Dimensions
*Night light * 30-50m / 210 ø5 built-in infrared LED
Installation and Operation Manual
CCTV
S6I.46908.640.EN RL. 00 13 03
ELVOX - Campodarsego - Italy
Via Pontarola, 14/a
35011 Campodarsego PD - Italy
Tel. +39 049 920 2511
Fax +39 049 920 2603
www.elvox.com
46908.640
850nm IR spotlight, projection 30-50m 60°
CCTV
CCTV
EN
EN
CCTV
