Villager VLN 9120, Original Instruction Manual

Page: 16 / 82

7
Villager VLN 9120 (GB)
Operation
Note: For instructions regarding charging batteries and further information on the
Villager 18V batteries please read the supplied instructions with the Villager 18V
battery charger or batteries.
IMPORTANT: Villager 18V li-Ion batteries (not supplied) must only be charged with
an Villager 18V battery charger (not supplied).
Installing a battery
•
Fit a charged battery by sliding it onto the base of the worklight until it clicks
and locks into position.
NOTE: Make sure the battery and worklight are lined up correctly. If the battery
does not slide onto the base of the worklight easily, don’t force it. Instead, slide the
battery out of the worklight and check the top of the battery and the battery slot of
the worklight are clean and undamaged, and that the contacts are not bent.
Removing a battery
•
Remove the battery from the worklight by pressing the battery release button
on the battery; then slide the battery off the base of the worklight.
WARNING: DO NOT try to remove the battery without pressing the battery release
button, otherwise the product or battery may be damaged!
Operating the Worklight
•
Switch the Torch on or off by pressing the On/Off Switch (4)
•
Adjust the Spotlight (1) direction by turning the Spotlight (1) at the Swivel Joint
(2). It adjusts from 0 - 270° with 6 click stop positions.
•
Adjust the torch head assembly angle at the Angle Joint (3). It adjusts from 0 -
180° with 6 click stop positions.
Note: Be careful not to damage the worklight when adjusting the angle and swivel
positions.
•
The worklight features a built in Hanging Hook (Image B). Push upwards to
release from the tool body.