Villager 18 V/1.65 A, Original Instruction Manual

Page: 12 / 63

3
•
Use the "Press" button on the battery to check the charging status; 1-4 red LEDs, where
1 indicates low battery status.
CHARGING THE BATTERY
•
The battery must be charged before it can be used with a tool.
•
If the LEDs on the charger do not go on when charging:
-
Check that the charger’s mains adapter is properly plugged into the power point and
that the charger is switched on.
- Check that the battery is correctly inserted in the charger.
1. Place the battery charger on a level and stable surface. Plug the charger into a 230 V
power point. The red LED on the charger goes on.
2. Connect the battery to the charger so that it clicks into place. The green LED goes on
and starts flashing, this indicates that the battery is charging. At the same time, the red
LED on the charger remains constantly red.
3. When the battery is fully charged, the red LED goes off and only the green LED stays on.