Viking VX 900 MHz LTR, User Manual

Page: 58 / 234

REPEATER PROGRAMMING
5-2
October 1999
Part No. 001-2009-201
Table 5-1 REPEATER SETUP PARAMETERS
Parameter Response Description
Repeater Number 1-20 Each repeater is assigned a Home Repeater number from 1-
20.
Channel Number 1-399 Each repeater is programmed with a number of the channel
that it is operating on.
Telco Network Type None
FSK
RS232
FSK Blank & Burst
TIC
VNC Data signaling type for RNT, FSK, RS232 or FSK B&B.
None=LTR dispatch only.
TIC is for Telephone Interface Card w/o RNT.
VNC=network telephone interconnect w/o RNT.
Area 0, 1 Same as value of the Area bit in the mobiles.
Sync Repeater Yes, No Not used.
Stand Alone Yes, No Select if the repeater is not connected to additional repeaters
(via HSDB).
ID Validator Yes, No Not used.
CWID Time 0 = disabled
1-60 min Time between CWID transmissions.
CWID Message 15 characters/numbers
UPPER CASE Station call letters.
Local MIC ID 0 = disabled (default)
1-250, 253 Group ID transmitted when the local microphone PTT is
active.
Test Mode ID 0 = disabled
1-250,
254 (default) Group ID transmitted when the Repeater is in the Test Mode.
RF Power Level 25-75, 75-160 Power level in watts for transmit power.
Power Source AC or DC The type of primary power source for the Repeater.
Paging Yes, No Select if a paging terminal is installed.
Data Modem Yes, No Select if the Data Modem option is installed.