Viking GE 355, Instruction Manual

Page: 55 / 545

53
DE
FR
NL
IT
ES
PT
NO
SV
FI
DA
PL
SL
SK
HU
EN
0478 201 9907 D - EN
Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Fuse in UK plug damaged (only applies
to machines for UK)
– Feed chute not properly closed - safety
cut-off switch actuated (safety interlock)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (
Ö
8.8),
(
Ö
10.7)
– Check power cable and fuse
#
(
Ö
10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician)
#
(
Ö
10.1)
– Replace fuse
#
(
Ö
10.1)
– Close feed chute properly and tighten
screws (
Ö
11.3)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
(
Ö
11.4)
– Reset locking device (
Ö
11.6)
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
– Incorrectly ground blades
– Power cable too long
– Bent blade disc
Remedy:
– Replace or re-sharpen shredding
blades (
Ö
11.9), (
Ö
11.10)
– Sharpen blades correctly
#
(
Ö
11.9)
– Use shorter power cable (
Ö
10.1)
– Check blade disc visually
#
Fault:
Shredding material is not drawn in
Possible cause:
– Incorrect rotational direction of blade
disc
– Blunt or incorrectly ground blades
Remedy:
– Change rotational direction of blade
disc (
Ö
10.7)
– Regrind combination blade and ensure
sharpening angle is exactly correct
#
(
Ö
11.9)
Fault:
Feed chute cannot be fitted
Possible cause:
– Locking device is not released
Remedy:
– Release locking device (
Ö
11.6)
20.
1
Handover confirmation
20.2 Service confirmation
Please hand this instruction manual
to your VIKING specialist dealer in
the case of maintenance work.
He will confirm the service operations
performed in the pre-printed boxes.
1
9. Troubleshooting
#
If necessary, contact a specialist
dealer; VIKING recommends VIKING
specialist dealers.
20. Service schedule
Service performed on
Next service date
25