Viking GB 370 S, Instruction Manual

Page: 42 / 478

0478 216 9901 D - EN
40
– Blade
– Blade disc
– V-belt
2. Compliance with the information in
this instruction manual
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Improper use of the product.
– Use of fuel and lubricants not approved
by VIKING (lubricants, petrol and
engine oil, see engine instruction
manual).
– Product modifications not approved by
VIKING.
– The use of attaching parts, attachments
or cutting tools not approved by
VIKING.
– Use of the product for sporting or
competitive events.
– Resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
VIKING recommends that you have
maintenance operations and repairs
performed exclusively by a VIKING
specialist dealer.
VIKING specialist dealers regularly attend
training courses and are provided with
technical information.
If these operations are neglected, faults
may arise which are the responsibility of
the user.
These include:
– Corrosive and other resultant damage
caused by incorrect storage.
– Damage and resultant damage due to
the use of spare parts which are not
original VIKING parts.
– damage due to maintenance and repair
operations not performed in the
workshops of authorised specialist
dealers.
1 3. 1 Pulling or pushing the
garden shredder
● Hold the garden shredder at the
upper chute (1) and tilt to the rear.
● The garden shredder can be pulled or
pushed slowly (walking pace).
1 3.2 Lifting or carrying the
garden shredder
● When lifting the garden shredder, hold it
at the housing on the right and under
the engine on the left.
1 3.3 Transporting the garden
shredder on a load floor
● Always place the garden
shredder in the upright position when
transporting it on a load floor.
● Secure the machine against slipping
using suitable fastening materials.
Attach ropes or straps to the wheel
carrier (1) and the feed chute (2).
Blade disc assembly
6903 700 5101
Reversible blade (2x)
6903 702 0101
V-belt
6001 704 2100
1 3. Transport
Risk of injury!
Before transporting, carefully read
and observe the section "For your
safety", in particular the
"Transporting the machine" section.
(
Ö 4.4)
2 1
Due to its heavy weight, at least two
persons are required to lift the
garden shredder. Always wear
suitable protective clothing; the
lower arms and upper part of the
body must be fully covered.
1 4. Standard spare parts
22
23