Step 2: Cooler/Trunk Frame Assembly
Position the port and starboard brackets onto the
center of the cooler rack rear tube as shown in figure
2. Attach the brackets using two 8mm x 55mm hex
bolts, washers and locknuts. Finger tighten only.
Attach this assembly to the column tube at the
desired position and secure using one 10mm x
70mm hex bolt, washer and locknut as shown in
Figure 3. Tighten securely, then reverse the
locknut until the brackets just rotate freely on the
column tube. Now verify the rack is centered on
the column tube and securely tighten the two
8mm x 55mm bracket bolts. Note: the larger
cooler rack must be mounted on the bottom and
the smaller cooler rack on top.
Stack-Rack II (VSR201)
Double Cooler/Trunk Rack
Assembly and Use Instructions
Assembly Tools Required:
Adjustable Crescent Wrench
13mm Box Wrench or Socket
16mm Box Wrench or Socket
Stack
Stack
Stack
Stack----Rack II
Rack II
Rack II
Rack II
Parts Overview
Port Mounting
Bracket
Column Tube
Tie-Down Rings
Receiver Tube
Starboard Mounting
Bracket
Cooler Rack
Step 1: Attaching Column Tube to the Receiver Tube
The Column Tube is attached to the Receiver Tube
using one 12mm x 80mm hex bolt, flat washer and
locknut, and the
12mm curved
clevis pin. Attach
the Column Tube
as shown in
figure 1. Tighten
the 12mm hex
bolt securely,
then reverse the
nut until the
column tube is
just free to rotate.
Figure 2
10mm x 70mm
Hex Bolt
Receiver Clevis
Pin Hole
10mm Washer and
Locknut this side
Port Bracket
Starboard Bracket
Smaller
Cooler Rack
8mm x 55mm
Hex Bolts
Figure
1
Receiver Tube
Column Tube
12mm x 80mm Hex Bolt
12mm Clevis Pin & Cotter Pin
12mm Washer and
Locknut this side
Figure 3
Larger Cooler
Rack
