background image

INSTALLATION 
INSTRUCTIONS

BUILT-IN ELECTRIC WARMING DRAWER
(INDOOR AND OUTDOOR MODELS)

VIKING RANGE CORPORATION

111 FRONT STREET

GREENWOOD, MISSISSIPPI 38930 USA

(662) 455-1200

IMPORTANT - PLEASE READ AND FOLLOW

•Before beginning, please read these instructions completely and carefully.
•Do not remove permanently affixed labels, warnings, or plates from the product.  This may void the warranty.
•Please observe all local ordinances.  If local codes are applicable, wire in accordance with the National Electrical Code,

ANSI/NFPA 70 - latest edition.

•WARNING - To reduce the risk of electric shock and fire, do not use a flexible power-supply cord with this appliance.  
•WARNING - FOR OUTDOOR INSTALLATION, INSTALLER MUST INSTALL A GROUND FAULT INTERRUPT.
•The installer should leave these instructions with the consumer who should retain for local inspector’s use and for

future reference.

WARNING!!!

Make sure that incoming voltage is the same as unit rating.  An electric rating plate specifying voltage,
hertz, wattage, amps, and phase is attached to the product.  Wiring the warming drawer with more
voltage than it is rated for may cause severe damage to the thermostat, element, and other components.
Wiring the warming drawer with less voltage than it is rated for may cause significant decrease in
performance.  To reduce the risk of fire, electric shock, or injury to persons, installation work and electrical
wiring must be done by qualified people in accordance with all applicable codes and standards, including
fire-rated conditions.  

GENERAL INFORMATION

THIS UNIT IS NOT TO BE INSTALLED BELOW CABINETS OR WALL MOUNTED.

•When installing this unit directly below other units, only install with Viking built-in products 
•Remove warming drawer carefully from carton.  Remove all loose packaging and accessories.  
•It is the responsibility of the installer to comply with local codes.  If no local codes are applicable, wire in accordance with

the National Electrical Code, ANSI/NFPA 70 - latest edition.

•This appliance is not fused.  Protect with a proper sized fuse or circuit breaker and a GFI for outdoor models.
•Line disconnect switch, circuit breaker, GFI (for outdoor models) or plug/receptacle of power cord connection should be

readily accessible to the operator.

•Ground unit per applicable electrical codes.
•Any installation not matching the specifications discussed in these instructions will void the manufacturer’s warranty.

ELECTRICAL CONNECTION

USE COPPER CONDUCTORS ONLY.  

GROUNDING INSTRUCTIONS 

This appliance must be connected to a grounded metal, permanent wiring system, or an equipment-grounding

conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on

the appliance.

With the appliance positioned in front of the cabinet opening, connect wire leads extending from the power supply
to the terminal block of the unit.  Make sure the colored wires of the terminal block are connected to the
corresponding colored wires extending from the power supply.  

1

Reviews: