Viking VK1910 Halo
Led Wash / Beam Zoom
Instructions
This Led light is designed to create washes,in air effects of beams or Eye Candy
with a lit Halo effect in the head itself. It uses 19 x 4in 1 Led for the beam and
30 x 3in1 Led for the Head Halo Effect.
The unit has 2 DMX modes of operation - 14 Channel (Beam only) and 25 Channel
for Bean & Halo.
On Power up the unit will great you with a welcome message & short delay while
the unit initialises. When complete the DMX address will be shown
with the message: Ready!
The Green DMX Signal light will flash when DMX is received and remain
constantly lit when no DMX is present. The Red Power light will only remain lit
during initialising the unit after which the LCD display shows power is present and
DMX signal is OK.
There after you can set the DMX address, set Channel Mode, Switch on/off LCD
& invert the display if hanging the unit.
2 Quick Rig Truss Hooks with Omega Clamps are provided for hanging -
these should not be removed from the Omega Clamps.
To set DMX Number just rotate the encoder to display the new number and
Press the decoder to set and save it.
LCD Menu: Options in the LCD Menu are selected by pressing the decoder or
scrolled through by rotating the decoder.
Main Menu Options are:
1) Dmx Address: Rotate the encoder to the desired DMX Address and press to store.
The unit will then return to the default screen showing DMX Number & Ready
2) Channel Mode: Standard (14 channel) Or Extended (25 Channel) To select rotate
the encoder and highlight required mode & press to select. The Main menu will then
reappear.
Channel
Value
Function
Beam shutter
0-1
Shutter Open
02-64
Snap on - Fade Off Pulse slow to fast
1
65-127
Fade On - Snap Off Pulse slow to fast
128-190
Slow Strobe slow to fast
191-253
Fast Strobe slow to fast
254-255
Shutter Open
2
0-255
Dimmer
3
0-255
Zoom Wide to Narrow
4
0-255
Pan 0-540 degrees
5
0-255
Pan Fine 16 bit
6
0-255
Tilt 0-212 degrees
7
0-255
Tilt Fine 16 Bit
Function
0-59
No Function
60-64
Fans Full Speed when cut in
65-69
No Function
70-74
Fans Adjust Speed to temperature of head when cut in
75-79
No Function
80-84
LCD Display Normal Orientation
85-89
No Function
8
90-94
LCD Display Inverted (for use when fixture hung )
95-99
No Function
100-104
LCD Display On
105-109
No Function
110-114
LCD Display off after 15 seconds
115-119
No Function
120-124
Head Reset if selected >3 sec
125-255
No Function
LED Macro
0-3
No Function
9
4-67
Beam Colour Macro RGB Slow to Fast
68-131
Beam Colour Macro RGB AND White Slow to Fast
132-255
Beam Colour Macro 3 Function
