VIKING GARDEN MT 4097 S, Instruction Manual

Page: 46 / 306

0478 192 9804 B - EN
44
Insert the battery (1). Stow both
connection cables in the battery
compartment properly.
● Close the battery
compartment. (
Ö 14.17)
14.19 Charging the battery using the
charger plug
The VIKING ACB 010 battery float charger
or the VIKING ADL 012 diagnostic charger
(both not included in standard equipment)
can be connected to the charger plug.
Only float charging can be performed with
the VIKING ACB 010 battery float charger.
Both float charging and full charging
(charging an empty battery) can be
performed with the ADL 012 diagnostic
charger.
Before connecting:
● Read and observe the information in
the instructions for the VIKING
chargers.
● Read and observe the instructions in
the battery supplementary sheet.
Connecting:
● Stop the engine. ( Ö 12.3)
● Engage the parking brake. ( Ö 8.12)
● Open the engine hood. ( Ö 14.3)
Only connect the VIKING ACB 010 battery
float charger or the VIKING ADL 012
diagnostic charger to the charger plug (1).
14.20 Combustion engine
Observe the operating and maintenance
instructions contained in the attached
engine instruction manual.
To achieve a long service life, it is always
particularly important to maintain a
sufficient level of oil and to change the
engine oil and air filter regularly.
14.21 Gearbox
For the user, the gearbox is maintenance-
free.
During the inspections of the machine by
the specialist dealer, the required
maintenance operations are performed on
the gearbox.
14.22 Storage
● Store the machine in a dry and dust-
free room out of reach of children and
unauthorised persons.
● Any machine faults must be remedied
prior to storage in order to maintain a
safe operating condition.
● Close the fuel cock. ( Ö 14.8)
● Remove the ignition key and keep in a
place where no unauthorised persons,
especially children, can access it.
Avoid damage to the machine.
Never charge the battery when the
engine is running.
Only the VIKING ACB 010 battery
float charger or the VIKING
ADL 012 diagnostic charger may
be connected to the charger plug.
Other chargers, particularly those
with a higher charging current, can
damage the machine.
In order to charge the battery using
another chargers, it must first be
removed.